Electrical System 16-65 fuses

30 A Main Fuse Removal

• Remove the right side cover (see Side Cover Removal in the Frame chapter).

• Unlock the hook to lift up the lids of the main fuse cover [A].

• Pull up the main fuse cover with the starter relay connec­tor.

Junction Box Fuse Removal

• Remove the left side cover (see Side Cover Removal in the Frame chapter).

• Unlock the hook to lift up the lid from the junction box.

• Pull the fuses [A] straight up from the junction box with the nose plier.

Junction Box Fuse Installation

• If a fuse fails during operation, inspect the electrical sys­tem to determine the cause, and then replace it with a new fuse of proper amperage.

• Install the junction box fuses on the original position as specified on the lid.

Fuse Inspection

• Remove the fuse.

• Inspect the fuse element.

• If it is blown out, replace the fuse. Before replacing a blown fuse, always check the amperage in the affected circuit. If the amperage is equal to or greater than the fuse rating, check the wiring and related components for a short circuit.

Housing [A] Fuse Element [B] Terminals [C] Blown Element [D]

CAUTION

When replacing a fuse, be sure the new fuse matches the specified fuse rating for that circuit. Installation of a fuse with a higher rating may cause damage to wiring and components.

APPENDIX 17-1 17