Electric Starter System. • Remove the terminal nut [A], and take the brush plate [B] off the end cover [C]

• Remove the terminal nut [A], and take the brush plate [B] off the end cover [C].

Starter Motor Assembly

• Replace any O-ring removed with a new one.

• Install the terminal bolt.

• Tighten the terminal nut.

Torque - Starter Motor Terminal Nut: 6.9 N-m (0.7 kgf-m, 61 in-lb)

• Install the brush plate on the end cover, align the tab [A]
on the plate with the slot [B] in the cover.

• Insert the armature into the yoke.

• Install the end gear cover [A] and O-ring [C] on the yoke housing [B], and align the projection [D] on the housing with the notches [E] in the gear housing.

• Install the end cover on the yoke housing, and align the short and wide tab [A] on the brush plate with the notch [B] in the housing.