Connect

Adapter’s positive (+) terminal → yellow wire terminal

Adapter’s negative (–) terminal → black wire terminal

OTurn the starter motor for several seconds and read the maximum value on the tester.

Crankshaft Sensor Peak Voltage
Standard: DC 3 V or more

• If the peak voltage is lower than the standard, inspect the
crankshaft sensor.

Diodes Inspection

• Remove:

Lower Right Fairing (see Lower Fairing Removal in the Frame chapter)

• Disconnect the diode assembly [A].

• Zero the hand tester, and connect it to the diode terminal to check the resistance in both directions.

•The resistance should be low in one direction and more than ten times as much in the other direction. If any diode shows low or high in both directions, the diode is defective and the diode assembly must be replaced.