Главная Случайная страница Контакты | Мы поможем в написании вашей работы! | ||
|
Stem Bearing Removal
• Remove the steering stem (see Steering Stem Removal).
•○DR rei vmeoovuetththeeobuetearrirnagceosutperrersasceedsinfrtoomthtehehehaedadpippeipues. ing
the head pipe outer race remover [A], and hammer the head pipe outer race remover to drive it out.
Special Tool - Head Pipe Outer Race Remover ID > 37 mm: 57001-1107
NOTE
○If either steering stem bearing is damaged it is recommended that both the upper and lower bearing (including outer races) should be replaced with new ones.
• Remove the lower inner race [A] (with its grease seal)
which is pressed onto the steering stem, with the steering
stem bearing puller [B], [C] and adapter [D].
Special Tools - Bearing Puller: 57001-158
Bearing Puller Adapter: 57001-317 Bearing Puller: 57001-1575
Stem Bearing Installation
• Replace the outer races with new ones.
• Apply grease to the outer race, and drive them into the head pipe using the drivers and press shaft [A].
Special Tools - Head Pipe Outer Race Press Shaft: 57001
-1075 [A] Head Pipe Outer Race Driver, 046.5: 57001
-1106 [B] Head Pipe Outer Race Driver, 051.5: 57001
-1076 [C]
• Replace the inner races with new ones.
• Apply grease to the lower inner race [A], and drive it onto the stem using the driver and adapter.
Special Tools-Steering Stem Bearing Driver: 57001-137 [B] Steering Stem Bearing Driver Adapter, 034.5: 57001-1074 [C]
Дата публикования: 2014-12-25; Прочитано: 339 | Нарушение авторского права страницы | Мы поможем в написании вашей работы!