Footpeg (from Top of the footpeg to Top of the brake Pedal)

• If it is incorrect, adjust the brake pedal position.

Brake Pedal Position Adjustment

NOTE

О Usually it is not necessary to adjust the pedal position, but always adjust it when push rod locknut has been loosened.

• Loosen the locknut [A], and turn the push rod [B] in or out to adjust the brake pedal position.

• Tighten the locknut.

• After adjusting brake pedal position, check the rear brake light switch timing, and adjust them if necessary (see Brake Light Switch Operation Inspection in the Periodic Maintenance chapter).

Brake Pedal and Shaft Removal

• Remove the front right footpeg bolt [A].

• Remove the brake pedal bolt [B], and remove the brake pedal.

• Remove the cotter pin [C], and pull out the pin [D] to sepa­rate the brake pedal shaft and master cylinder brake rod.