![]() |
Главная Случайная страница Контакты | Мы поможем в написании вашей работы! | |
|
Sprocket, Coupling
![]() |
Engine Sprocket Removal • Remove the bolts [A]. Pull the engine sprocket cover [B].
![]() |
• Flattenoutthebendedwasher[A].
• Removetheenginesprocketnut[B]andwasher.
NOTE
○When loosening the engine sprocket nut, hold the rear brake on.
• Loosen the drive chain (see Drive Chain Slack Inspection in the Periodic Maintenance chapter).
• Pull the engine sprocket [A] off the output shaft along with the chain. Remove the engine sprocket.
Ц ffMMOl S |
![]() |
Engine Sprocket Installation
• Replace the sprocket washer with a new one.
• Install the engine sprocket so that the "OUTSIDE" mark [A] faces out.
• Be sure to fit the sprocket washer onto the output shaft splines.
• Apply oil to the threads of the output shaft [C] and the seating surface of the engine sprocket nut.
• After torquing the engine sprocket nut [A], bend the one side [B] of the washer over the nut.
NOTE
OTighten the nut while applying the rear brake.
Torque - Engine Sprocket Nut: 127 N-m(13.0 kgf-m, 94ft-lb)
• Install the engine sprocket cover.
• Adjust the drive chain slack after installing the sprocket (see Drive Chain Slack Inspection in the Periodic Maintenance chapter).
Дата публикования: 2014-12-25; Прочитано: 229 | Нарушение авторского права страницы | Мы поможем в написании вашей работы!