![]() |
Главная Случайная страница Контакты | Мы поможем в написании вашей работы! | |
|
CAUTION |
When inserting the release shaft, be careful not to remove the spring of the oil seal. |
• Apply high temperature grease to the oil seal lips in the clutch cover.
• Apply engine oil to the bearings in the hole of the clutch cover.
• Apply engine oil to the release shaft.
• Turning the release lever toward the rear, insert the release shaft straight into the hole of the clutch cover.
![]() |
• Install the clutch inner cable tip in the release lever.
• Turn the release lever clockwise until it becomes hard to turn.
○The release lever should have proper clearance and angle as shown.
1 ∼ 3 mm
80° ∼ 90°
Дата публикования: 2014-12-25; Прочитано: 213 | Нарушение авторского права страницы | Мы поможем в написании вашей работы!