Maintenance Procedure. Radiator Hoses and O-ring Replacement

Radiator Hoses and O-ring Replacement

• Drain the coolant (see Coolant Draining).

• Remove:

Lower Fairings (see Lower Fairing Removal in the Frame

chapter)

Spark Plug Caps

Thermostat Housing Cover [A]

Pipe [B]

Hoses [C]

O-rings [D]

To Cylinder Head [E]

To Carburetor [F]

To Cylinder [G]

• Apply grease to the new O-rings and install them.

• Install the hoses and tighten the clamps securely.

• Fill the coolant (see Coolant Filling). Check the cooling system for leaks.

Engine Oil Change

• Warm up the engine so that the oil will pick up any sedi­ment and drain easily. Then stop the engine.

• Support the motorcycle perpendicular to the ground, and place an oil pan beneath the engine.

• Remove the engine oil drain plug [A], and let the oil drain completely.

• If the oil filter is to be changed, replace it with a new one.

• Check the gasket at the drain plug for damage.

• Replace the gasket with a new one if it is damaged. After the oil has completely drained out, install the drain plug with the gasket, and tighten it.

Torque - Engine Oil Drain Plug: 29 N-m (3.0 kgf-m, 22 ft-lb)

Периодический ремонт 2-45 Maintenance Procedure

• Fill the engine with a good quality motor oil specified in
the table.

Torque - Oil Filler Plug: 1.5 N·m (0.15 kgf·m, 13 in·lb)

• Checktheoillevel.