Power window control unit AQR 200 user manual

APPLICATION

Controller AQR-200 is intended to control by two electrical motors in one direction.

Controller can operate in either controlled-duration or full travel type.

THE WORKING PRINCIPLE OF A POWER WINDOW SWITCH

To activate the window motor it must have +12 V on one of it leads and "ground" on the other in order to operate.

The switch, while at rest, may connect both these wires: t0 ground, or to +12 V (ignition).

When activated, all type of switches will send +12 V one wire and ground on the other.

Which wire receives +12 V and which wire receives ground depend on the direction the window will go.

A lot of vehicles reverse polarity of motors by pressing the control buttons without relays, but in some vehicles there is used relays. In this case the AQR-200 must connected between the relays and motors.

To control the windows by switches and although b security system you need the controller.

CONTROLLER CONTROL

The control input (yellow wire) it needed to connect with car alarm system output, which grounded in arm mode. If the system disarmed, by pressing control buttons it is possible to establish glasses in any position, and when the system is; arming the glasses automatically will completely rise.

Drawings below show the different AQR-200 and vehicle interfaces:

INTERFACE 1. Control two power windows. Switch outputs ground at

Rest.

INTERFACE 2. Control two power windows. Switch outputs is +12 V at rest.

Задание 4. Методика моделирования текста Изучив специфи­ку жанра инструкции (И.С.Алексеева, С. 176-181, 272-273,, смоделируйте собственный текст «по законам» этого жанра. Пример приведен в приложении 2.