Electrical Wiring

Wiring Inspection

• Visually inspect the wiring for signs of burning, fraying, etc.

• If any wiring is in poor condition, replace the damaged wiring.

• Pull each connector [A] apart and inspect it for corrosion, dirt, and damage.

• If the connector is corroded or dirty, clean it carefully. If it is damaged, replace it.

• Check the wiring for continuity.

OUse the wiring diagram to find the ends of the lead which

is suspected of being a problem. OConnect an ohmmeter between the ends of the leads. OSet the meter to the × 1 Q range, and read the meter.

• If the meter does not read 0 Q, the lead is defective. Re­
place the lead or the wiring harness [B], [C] if necessary.