Главная Случайная страница Контакты | Мы поможем в написании вашей работы! | ||
|
• Install the spacer onto the drive shaft, facing the chamfered side to the ball bearing.
• Check that each gear spins or slides freely on the drive shaft without binding.
Output Shaft Assembly
• Assembly is the reverse of disassembly. Note the following.
• Apply engine oil liberally to the output shaft, gears, bearings, bushing and O-ring.
• Install the output shaft ball bearing, O-ring and collar using the bearing driver.
Special Tool - Bearing Driver, 3 2: 57001-382
OThe ball bearing, O-ring and collar ought to be installed individually.
• Replace any circlips that were removed with new ones.
OAlways install circlips so that the opening is aligned with a spline groove. To install a circlip without damage, fit the circlip onto the shaft expanding it only enough to install it, and use a suitable gear to push the circlip into place.
Circlip
Toothed Washer
• When assembling the output shaft 3rd/4th gear bushing [A] to the shaft, align its oil holes [B] with the holes in the shaft.
Дата публикования: 2014-12-25; Прочитано: 241 | Нарушение авторского права страницы | Мы поможем в написании вашей работы!