Главная Случайная страница Контакты | Мы поможем в написании вашей работы! | ||
|
Oil Pressure Measurement
Oil Pressure Measurement
NOTE
○Measure the oil pressure after the engine is warmed up.
• Remove:
о |
WARNING |
Oil Passage Plug
If the oil passage plug is removed while the engine is warm, hot engine oil will drain through the oil passage; take care against burns.
• Attach the oil pressure gauge [A] and adapter [B] to the
oil passage hole.
Special Tools-Oil Pressure Gauge, 5 kgf/cm2: 57001-125 Oil Pressure Gauge Adapter, M14 x 1.5: 57001-1209
• Run the engine at the specified speed, and read the oil pressure gauge.
• If the oil pressure is significantly below the specification, inspect the oil pump and relief valve.
• If the oil pump and relief valve are not at fault, inspect the rest of the lubrication system.
Oil Pressure 275 ~ 335 kPa (2.8 ~ 3.4 kgf/cm2, 40 ~ 48 psi) @4 000 r/min (rpm), 90°C (194°F) of oil temp.
• Stop the engine.
• Remove the oil pressure gauge and adapter.
• Install the oil passage plug and tighten it.
Torque-Oil Passage Plug: 18 N-m (1.8 kgf-m, 13 ft-lb)
NOTE
О When binding the brake switch lead with the plastic clamp, make sure it does not touch the exhaust pipe.
H
Дата публикования: 2014-12-25; Прочитано: 287 | Нарушение авторского права страницы | Мы поможем в написании вашей работы!